EZ1000 Plus User Manual
6. Remove the cable tie from the connection
cable and extend the cable to its full
length. Now plug the cable connector into
the Ethernet module socket.
【
】
Be careful when removing the cable tie to avoid damage to the connection cable.
8. Secure the module on the printer housing
and plug the other end of the connection
cable into the socket on the motherboard.
9. Pass the connection cable underneath the
other connection cables as shown in the
illustration.
【
】
Please make sure that you position all cables in such a way that they are not
damaged when you reassemble the printer.
10. Finally, replace the top part of the printer
housing and secure it on the underside of
the printer using the screws you removed
earlier.
【
】
Once you have finished installing the Ethernet module, the command "^XSET,USBETHERNET,1"
must be sent to the printer to enable the Ethernet module. While the Ethernet module is
enabled, the USB port is disabled. To enable it again, send the command
"^XSET,USBETHERNET,0" to the printer.
