Dil ID: 9
Dil Adı: germany
Dil Kodu: de2tayfun Produkte der Marke ELEKTRO HELIOS
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Obey the maximum load volume of 7 kg (refer to the “Programme chart” chap-
ter).
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
The operating water pressure (minimum and maximum) must be between 0,5
bar (0,05 MPa) and 8 bar (0,8 MPa)
The ventilation openings in the base (if applicable) must not be obstructed by
a carpet.
The appliance is to be connected to the water mains using the new supplied
hose-sets. Old hose sets must not be reused.
Safety instructions
Installation
Remove all the packaging and the transit bolts.
Keep the transit bolts. When you move the appliance
again you must block the drum.
Do not install or use a damaged appliance.
Do not install or use the appliance where the temper-
ature is less than 0 °C or where it is exposed to the
weather.
Obey the installation instruction supplied with the ap-
pliance.
Make sure that the floor where you install the appli-
ance is flat, stable, heat resistant and clean.
Do not install the appliance where the appliance door
can not be fully opened.
Always be careful when you move the appliance be-
cause it is heavy. Always wear safety gloves.
Make sure that there is air circulation between the
appliance and the floor.
Adjust the feet to have the necessary space between
the appliance and the carpet.
Electrical connection
Warning! Risk of fire and electrical shock.
The appliance must be earthed.
Make sure that the electrical information on the rating
plate agrees with the power supply. If not, contact an
electrician.
Always use a correctly installed shockproof socket.
Do not use multi-plug adapters and extension cables.
Make sure not to cause damage to the mains plug
and to the mains cable. Contact the Service or an
electrician to change a damaged mains cable.
Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is ac-
cess to the mains plug after the installation.
Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.
Do not touch the mains cable or the mains plug with
wet hands.
This appliance complies with the E.E.C. Directives.
Water connection
Make sure not to cause damage to the water hoses.
The appliance is to be connected to the water mains
using the new supplied hose-sets. Old hose sets
must not be reused.
Before you connect the appliance to new pipes or
pipes not used for a long time, let the water flow until
it is clean.
The first time you use the appliance, make sure that
there is no leakage.
Use
Warning! Risk of injury, electrical shock, fire,
burns or damage to the appliance.
Use this appliance in a household only.
Do not change the specification of this appliance.
3