35°
45°
Open the porthole and extract the inlet hose.
Connect the hose with the angled connection to the
machine. Do not place the inlet hose downwards. An-
gle the hose to the left or right depending on the posi-
tion of your water tap.
Set the hose correctly by loosening the ring nut.
Connect the hose to a tap
with a 3/4” thread.
• After positioning the inlet hose, be sure to tighten
the ring nuts again to prevent leaks.
• The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially de-
signed for this type of use.
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge
of a sink using the plas-
tic hose guide.
In this case, make sure the end cannot come un-
hooked when the machine is emptying. This could be
done by tying it to the tap with a piece of string or at-
taching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm. The end of the
drain hose must always be ventilated, i.e. the inside
diameter of the drain pipe must be larger than the out-
side diameter of the drain hose. The drain hose must
not be kinked.
Environmental concerns
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product,
please contact your local council, your household waste
disposal service or the shop where you purchased the
product.
Packaging materials
The materials marked with the symbol
are recycla-
ble.
>PE<=polyethylene
>PS<=polystyrene
27
