• The quality of the detergent can be the
cause.
Dishes are wet
• The program is without a drying phase
or with a low temperature drying phase.
Leave the door ajar for some minutes
before you remove the dishes.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the multi-tablets can be
the cause. Try a different brand or acti-
vate the rinse aid dispenser and use
rinse aid together with multi-tablets.
Refer to “HINTS AND TIPS” for
other possible causes.
10.2 How to activate the rinse
aid dispenser
1.
Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to “Set-
ting and starting a program”.
2. Press and hold, at the same time,
Program and MyFavourite until the
indicators of Delay, Program and My-
Favourite start to flash.
3.
Press Program.
• The indicators of Delay and MyFa-
vourite go off.
• The indicator of Program continues
to flash.
• The display shows the current set-
ting.
Rinse aid dispenser off.
Rinse aid dispenser on.
4. Press Program to change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6. Adjust the released quantity of rinse
aid.
7.
Fill the rinse aid dispenser.
11. TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 550
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity Place settings 14
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
2)
If the hot water comes from alternative sources of energy, (e.g. solar panels, wind turbine
energy), use the hot water supply to decrease energy consumption.
ENGLISH 17
