Dil ID: 9
Dil Adı: germany
Dil Kodu: de1tayfun Produkte der Marke Electrolux
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



11.2 Cleaning the spray arms
Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.
11.3 External cleaning
Clean the appliance with a moist soft
cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents.
11.4 Internal cleaning
Carefully clean the appliance, including
the rubber gasket of the door, with a
soft damp cloth.
If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per
month.
To maintain the performance of your
appliance at its best, we recommend
to use monthly a specific cleaning
product for dishwashers. Follow
carefully the instructions on the
packaging of the product.
12. TROUBLESHOOTING
If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with the
help of the information in the table.
With some problems, the display
shows a message.
Problem Possible solution
You cannot activate the appli-
ance.
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is no damaged fuse in the
fuse box.
The programme does not start. Make sure that the appliance door is closed.
Press OK
If the delay start is set, cancel the setting or wait
for the end of the countdown.
The appliance has started the procedure to re-
charge the resin inside the water softener. The du-
ration of the procedure is approximately 5 mi-
nutes.
The appliance does not fill with
water.
The display shows the mes-
sage: Appliance is not filling wa-
ter.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is
not too low. For this information, contact your lo-
cal water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
www.electrolux.com20