Malfunction Fault code Possible cause Possible solution
The filter in the water in-
let hose is blocked.
Clean the filter.
The connection of the
water inlet hose is not
correct.
Make sure that the con-
nection is correct.
The water inlet hose is
damaged.
Make sure that the wa-
ter inlet hose has no
damages.
The appliance
does not drain
the water.
• The Indicator light of the
programme in progress
flashes.
• The end-of-programme
indicator light flashes two
times.
There is a blockage in
the sink spigot.
Clean the sink spigot.
The connection of the
water drain hose is not
correct.
Make sure that the con-
nection is correct.
The water drain hose is
damaged.
Make sure that the wa-
ter drain hose has no
damages.
The anti-flood
device operates.
• The Indicator light of the
programme in progress
flashes.
• The end-of-programme
indicator light flashes
three times.
Close the water tap and
contact the service cen-
tre.
The programme
does not start.
The appliance door is
open.
Close the door correctly.
The mains plug is not
connected in.
Put in the mains plug.
Blow out fuse in the
household fuse box.
Replace the fuse.
Delay start is set. (Only
for appliances with delay
start).
To start immediately the
programme, cancel the
delay start.
After the check, switch on the appliance. The
programme continues from the point of in-
terruption.
If the malfunction shows again, contact the
service centre.
For other fault codes, not showed in the
chart, contact the service centre.
The necessary data for the service centre is
on the rating plate.
We recommend that you write the data here:
Model (MOD.) ....................
Product number (PNC) ....................
Serial number (S.N.) ....................
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The selected washing pro-
gramme was not applicable for
the type of load and soil.
Make sure that the washing pro-
gramme is applicable for the
type of load and soil.
electrolux 35
