daily use electrolux 25
Select and start a washing
programme
Select the washing programme
with the door slightly opened. The
start of the programme will occur
only after the closure of the door.
Until then it is possible to modify
the settings.
1. Check that the baskets have been
loaded correctly and that the spray
arms are free to rotate
2. Check that the water tap is opened
3. Press the On/Off button. The
dishwasher must be in setting
mode.
4. Press the button corresponding to
the required programme (see
‘Washing programmes’ chart).
The phase indicator lights foreseen
for that programme start flashing.
5. Close the dishwasher door, the
programme starts automatically.
Once the programme has started
the phase indicator lights will turn
off except for the phase under
way.
Interrupt or cancel a washing
programme in progress ONLY if it’s
absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
End of the washing programme
● The dishwasher will automatically
stop.
● The end of programme indicator
light is illuminated.
● The indicator light of the
programme just ended will remain
illuminated.
1. Switch off the dishwasher by
pressing the On/Off button.
Interrupt a washing programme in
progress:
● Open the dishwasher door; the
programme will stop. Close the
door; the programme will start from
the point at which it was
interrupted.
● Press the On/Off button (all
indicator lights will turn off); the
programme will stop. Press the
On/Off button again; the
programme will start from the point
at which it was interrupted.
Cancel a washing programme in
progress
● Simultaneously press and hold the
two programme buttons positioned
over the letter C, until all the
programme button lights and end
of programme indicator light are
illuminated.
The washing programme has been
cancelled.
● If a new washing programme is to
be selected, check that there is
detergent in the detergent
dispenser.
117989 12/3en 9-06-2007 10:57 Pagina 25
