Programme selection buttons
With these buttons you can select the wash-
ing programme. Press a programme button,
the related indicator light comes on. Refer to
'Washing programmes' chapter for more da-
ta about the washing programmes.
Function buttons
Use the function buttons for these opera-
tions:
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the audible signals.
Refer to the section 'Audible signals'.
• To activate/deactivate the multitab func-
tion. Refer to the chapter 'Multitab func-
tion'.
• To deactivate/activate the rinse aid dis-
penser when multitab function is active.
Refer to the chapter 'Multitab function'.
• To cancel the washing programme in pro-
gress or a delay start in progress. Refer to
the chapter 'Setting and starting a washing
programme'.
Setting mode
The appliance must be in setting mode for
these operations:
• To set a washing programme.
• To set the water softener level.
• To deactivate/activate the audible signals.
• To deactivate/activate the rinse aid dis-
penser.
Press the on/off button. The appliance is in
setting mode when:
– All the programme indicator lights come on
and the digital display shows three hori-
zontal bars.
Press the on/off button. The appliance is not
in setting mode when:
– Only one programme indicator light comes
on and the digital display shows one hori-
zontal bar.
– A washing programme is set. It is neces-
sary to cancel the programme to go back
to the setting mode. Refer to the chapter
'Setting and starting a washing pro-
gramme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water
softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
starts to flash.
– The end-of-programme indicator light
comes on.
The audible signals are activated.
5. Press the function button C again.
– The end-of-programme indicator light
goes off.
The audible signals are deactivated.
6. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the end-of-
programme indicator light comes on.
Use of the appliance
Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.
5. Set the correct washing programme for
the type of load and soil.
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing programme.
electrolux 73
