Problem Possible cause Possible solution
The quantity of detergent
was too much.
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Dry water drop
stains on glasses
and dishes.
The released quantity of
rinse aid was not sufficient .
Increase the released quantity
of rinse aid.
The quality of the detergent
can be the cause.
Try a different brand of deter-
gent.
The dishes are wet. The programme had no dry-
ing phase.
Set a programme with the
drying phase.
The dishes are wet
and matt.
The rinse aid dispenser is
empty.
Make sure that there is rinse
aid in the rinse aid dispenser.
The quality of the rinse aid
can be the cause.
Try a different brand of rinse
aid.
The quality of the combi de-
tergent tablets can be the
cause.
• Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the combi
detergent tablets.
Activating the rinse aid
dispenser with the multitab
function activated
1.
Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to ‘SETTING AND
STARTING A PROGRAMME’.
3. Press and hold touchpads (4) and (5) at
the same time until the indicators of
touchpads (3), (4), (5) and (6) flash.
4.
Press touchpad (4).
• The indicators of touchpads (3), (5)
and (6) go off.
• The indicator of touchpad (4) contin-
ues to flash.
• The display shows the setting of the
rinse aid dispenser.
Off
On
5.
Press touchpad (4) to change the set-
ting.
6.
Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse aid.
8.
Fill the rinse aid dispenser.
TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 446 / 818 - 898 / 550
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
80
www.electrolux.com
