Display message and malfunction Possible cause and solution
•
message DRAIN BLOCKED in the display
• point-shaped optical signal flashing
The dishwasher will not drain
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
•
SERVICE CODE
in the display
• point-shaped optical signal flashing
Anti-flood device is activated
• Close the water tap and contact your local
Service Force Centre.
The flashing of the point-shaped optical
signal on the floor beneath the dish-
washer door will not be visible if the ap-
pliance has been installed higher up with
a furniture door mounted flush.
Malfunction Possible cause and solution
The programme does not start
• The dishwasher door has not been properly
closed. (Message PLEASE CLOSE DOOR in
display).
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
Once these checks have been carried out
switch on the appliance.
The programme will continue from the point
at which it was interrupted.
If the message or malfunction reappears
contact your local Service Force Centre.
For other messages not described in the
chart, please contact your local Service
Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
This information can be found on the rating
plate located on the side of the dishwasher
door.
So that you always have these numbers at
hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The wash results are not satisfactory
The dishes are not
clean
• The wrong programme has been selected.
• The dishes are arranged in such a way as to stop water reaching all parts
of a surface. The baskets must not be overloaded.
• The spray arms do not rotate freely due to incorrect arrangement of the
load.
• The filters in the base of the washing compartment are dirty or incorrectly
positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes; the salt container is
empty or incorrect level of the water softener has been set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
The dishes are wet
and dull
• Rinse aid was not used.
• The rinse aid dispenser is empty.
18 electrolux
