Malfunction Fault code Possible cause Possible solution
Blow out fuse in the
household fuse box.
Replace the fuse.
Delay start is set. (Only
for appliances with de-
lay start).
To start immediately
the programme, cancel
the delay start.
After the check, switch on the appliance. The
programme continues from the point of in-
terruption.
If the malfunction shows again, contact the
service centre.
If the display shows other fault codes, con-
tact the service centre.
The necessary data for the service centre is
on the rating plate.
We recommend that you write the data here:
Model (MOD.) ....................
Product number (PNC) ....................
Serial number (S.N.) ....................
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The selected washing pro-
gramme was not applicable for
the type of load and soil.
Make sure that the washing pro-
gramme is applicable for the
type of load and soil.
The baskets were not loaded
correctly, water did not touch all
surfaces.
Load the baskets correctly.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
The filters are dirty or not as-
sembled and installed correctly.
Make sure that the filters are
clean and correctly assembled
and installed.
The quantity of detergent was
not sufficient or missing.
Make sure that the quantity of
detergent is sufficient.
Limescale particles on the
dishes.
The salt container is empty. Fill the salt container with dish-
washer salt.
Incorrect water softener adjust-
ment
Adjust the water softener.
The salt container cap is not
closed correctly.
Make sure that the salt container
cap is closed correctly.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Rinse aid dosage is too high. Decrease the rinse aid dosage.
Dry water drop stains on glasses
and dishes.
Rinse aid dosage is too low. Increase the rinse aid dosage.
The detergent can be the cause. Use a different brand of deter-
gent.
The dishes are wet. You have set a washing pro-
gramme without drying phase or
with a decreased drying phase.
Let the door stay ajar for some
minutes before you remove the
dishes.
electrolux 15
