6. Adjust the released quantity of rinse
aid.
7. Fill the rinse aid dispenser.
11. TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 550
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity Place settings 14
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
2)
If the hot water comes from alternative sources of energy, (e.g. solar panels, wind turbine
energy), use the hot water supply to decrease energy consumption.
12. INSTALLATION
If oor is not level, adjust
levelling legs to suit
The hos e s hould not be
extended by more than
2 metres or water pump-
out
problems ma y occu r
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
• K ickplate xing screws •
Gap on both sides should be
equal, & no greater than
5 mm per side.
600 mm max.
300 mm min.
Secure dishwasher with
brackets and screws provided
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and drain.
ENGLISH 17
