Avoid over tilting the machine during trans-
portation.
What to do if…
The dishwasher will not start or stops during
operation.
Certain problems can be due to the lack of
simple maintenance or oversights, which can
be solved with the help of the hints described
in the chart, without calling out an engineer.
Open the door, switch off the dishwasher
and carry out the following suggested cor-
rective actions.
Fault codes and malfunction Possible cause and solution
• continuous flashing of the running programme
light
• point-shaped optical signal is flashing
• intermittent audible signal
•
appears in the digital display
The dishwasher does not fill with water
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
• continuous flashing of the running programme
light
• point-shaped optical signal is flashing
• intermittent audible signal
•
appears in the digital display
The dishwasher will not drain
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
• continuous flashing of the running programme
light
• point-shaped optical signal is flashing
• intermittent audible signal
•
appears in the digital display
Anti-flood device is activated
• Close the water tap and contact your local
Service Force Centre.
The flashing of the point-shaped optical
signal on the floor beneath the dish-
washer door will not be visible if the ap-
pliance has been installed higher up with
a furniture door mounted flush.
Malfunction Possible cause and solution
The programme does not start • The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
Once these checks have been carried out
switch on the appliance and close the door.
The programme will continue from the point
at which it was interrupted.
If the malfunction or fault code reappears
contact your local Service Force Centre.
18 electrolux
