Installation
If oor is not level, adjust
levelling legs to suit
POWE R S UPPL Y
230/240V
-10Am
s
The hos e s hould not be
extended by more than
2 metres or water pump-
out
problems ma y occu r
Fix drain hose max of
10mm below the top of
the dishwashe r
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Gap on both sides should be
equal, & no greater than
5mm per side.
600mm max.
300mm min.
Secure dishwasher with
brackets and screws provided
Inlet water supply
• Cold water pressure: 800 kPa max - 50 kPa
min
• Water flow rate 10 L/minute min.
• If cold water pressure is in excess of 800 kPa,
a pressure-reducing valve should be used.
Check for leaks.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Caution! Obey the instructions in the
enclosed template to:
• build-in the appliance,
• install the furniture door,
• connect to the water supply and drain.
Install the appliance under a counter (kitchen
worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap and
drain.
For the venting of the appliance only water
hoses and mains cable openings are neces-
sary.
The appliance has adjustable feet to allow
the adjustment of its height.
Make sure that the water inlet hose, the drain
hose and the mains cable are not kinked or
squashed, when you insert the appliance.
Adjust the level of the appliance
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. Loosen or tighten
the adjustable feet until the appliance is level.
18 electrolux
