26
Cleaning the spray arms
Regularly check the nozzles in the three spray arms
for blockages. If necessary, clean the nozzles with a
piece of fine wire or a fine needle and a strong water
jet.
1 Do not damage the nozzle openings.
Top spray arm
1. Undo the fixing screw (A) by turning anti-clock-
wise.
2. Pull the spray arm off the shaft.
3. Clean the spray arm and the fixing screw.
4. Fasten the spray arm with the fixing screw (A) turn-
ing clockwise.
Middle spray arm
1. Remove the middle spray arm by turning it lateral-
ly.
The two-part spray arm bearing is held together by
a tension spring (B)
2. Clean spray arm nozzles.
3. To re-fit, press the middle spray arm upwards until
you feel it snap into place.
Lower spray arm
1. Undo the fixing screw (C) by turning anti-clock-
wise.
2. Pull the spray arm off the shaft.
3. Clean the spray arm and the fixing screw.
4. Fasten the spray arm with the fixing screw (C) turn-
ing clockwise.
