The cleaning results are not satisfactory
Dry water drop signs on
glasses and dishes
• Increase rinse aid dosage.
• The detergent can be the cause.
Technical data
Dimensions Width
Height
Depth
54,5 cm
44,7 cm
49,4cm
Electrical connection - Voltage -
Overall power - Fuse
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Water supply pressure Minimum
Maximum
0,8 bar (0,08 MPa)
10 bar (1,0 MPa)
Capacity 6 place settings
Installation
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Fitting the appliance
Important! Obey the instructions in the
enclosed template to:
• Build-in the appliance.
• Install the furniture panel.
• Connect to the water supply and drain.
Remove all packaging before you move the
dishwasher into position.
Put the appliance adjacent to a water tap and
a drain.
When you put the appliance in place, make
sure that the water hoses are not kinked or
squashed.
Install the appliance on a shelf in a furniture
of the kitchen.
Make sure that:
• The furniture is correctly attached to the
wall.
• The shelf for the dishwasher is correctly
attached in the furniture.
• The front edge of the shelf is level with the
sides of the furniture.
• The dishwasher is level on the shelf to op-
erate correctly.
Adjusting the level of the appliance
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the ad-
justable feet until the appliance is level.
Water connection
Inlet hose
The appliance has safety features to prevent
that the water in the appliance goes back into
the drinking water system.
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
It is important that a water tap or stopcock is
near the dishwasher with easy access.
Connect the inlet hose to a water tap with an
external thread of 3/4”.
If the water inlet hose is too short, replace the
water inlet hose with an applicable, longer
high-pressure hose. Do not connect an ex-
tension hose.
To suit the installation, it is possible to turn
the end of the hose that is connected to the
dishwasher. Do these steps :
1. Loosen the retaining nut.
2. Turn the hose.
3. Tighten the retaining nut.
14 electrolux
