- 17 -
A
B
Assembly SMS / EURO 4/6
1. Push the shelf backwards so that it is
3 mm behind the front edge of the base
of the cupboard. Screw it into place in
the middle of the sides (2x 24 mm
screws).
2. Screw the mount plate into place at the
front of the shelf. Make sure that it is
positioned in the centre laterally.
3. Hook the outer door into the hinge
brackets on the mount plate and align
the door front using the adjusting
screws A+B.
4. Lift off the outer door again. Remove
the mount plate and affix it in the front
part of the dishwasher’s bracket.
Fitting cap strips
(only applies for EURO assembly 60 cm)
1. Clean all surfaces where the strips are
to be attached to ensure better adhesion.
2. Attach the two gap strips along each
side of the cupboard, level with the
front edge of the sides. If there are too
long, there can easily be cut to the
right length.
Tab
SMS (4/6)
EURO (4/6)
2x
Plastic protective
strip
Mount plate
