4. Release function buttons B and C.
5. Press function button A.
– The indicator light for function button A
continues to flash.
– The indicator lights for function buttons
B and C go off.
– The end-of-programme indicator light
starts to flash.
The setting function of the water softener
is activated.
The end-of-programme indicator light
flashes to show the level of the water
softener. The pause is approximately 5
seconds.
Example: 5 flashes, pause, 5 flashes,
pause, etc. = level 5
6. Press the function button A one time to
increase the water softener level by one
step.
7. Press the on/off button to save the oper-
ation.
Use of dishwasher salt
Caution! Only use dishwashers salt.
Types of salt that are not applicable for
dishwashers cause damage to the water
softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
salt before you start a washing
programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the
salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
3. Use the funnel to fill the salt container with
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
It is normal that water overflows from the
salt container when you fill it with salt.
When you set electronically the water soft-
ener to level 1, the salt indicator light does
not stay on.
Use of rinse aid
Caution! Only use branded rinse aid for
dishwashers.
Do not fill the rinse aid dispenser with
other products (e.g. dishwasher clean-
electrolux 7
