– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
5. Press function button B again.
– The end-of-programme indicator light
comes on.
6. Switch off the appliance to save the op-
eration.
To deactivate the rinse aid dispenser do the
above steps until the end-of-programme in-
dicator light goes off.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
Setting and starting a washing programme
Set the washing programme with the
door ajar. The washing programme
starts only after you close the door. Until
then it is possible to modify the settings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press one of the programme buttons.
Refer to the chapter 'Washing pro-
grammes'.
– The programme indicator light comes
on.
– The digital display shows three hori-
zontal bars.
– The programme-in-progress indicator
light comes on.
4. Close the door.
– The washing programme starts auto-
matically.
– The programme-in-progress indicator
light remains on.
– The digital display shows only one hor-
izontal bar. It remains for all the dura-
tion of the washing programme.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
You can select the washing programme
and delay start also with the door closed.
When you press a programme button
you have only 3 seconds to select a dif-
ferent washing programme or a delay
start. After these 3 seconds, the selec-
ted programme starts automatically.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
1. Press and hold function buttons B and C
until:
– All the programme lights come on.
– The digital display shows three hori-
zontal bars.
2. Release function buttons B and C. The
washing programme is cancelled.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent
before you set a new washing programme.
Setting and starting a washing
programme with delay start
1. Switch on the appliance.
2. Set a washing programme.
3. Press the delay start button until the dis-
play shows on flashing the necessary de-
lay start of the washing programme.
4. Close the door.
– The countdown of the delay start
starts.
electrolux 13
