Problem Possible cause and solution
The appliance trips the cir‐
cuit-beaker.
• The amperage is insufficient to supply simultaneous‐
ly all the appliances in use. Check the socket amper‐
age and the capacity of the meter or turn off one of
the appliances in use.
• Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
For other messages or problems not
described in the table, contact an
Authorised Service Centre.
12.1 The washing and drying results are not satisfactory
Problem Possible cause and solution
Poor washing results. • Refer to "Daily use", "Hints and tips" and the
basket loading leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and the filter. Refer to "Care
and Cleaning".
Poor drying results. • Tableware has been left for too long inside the
closed appliance.
• There is no rinse aid or the dosage of rinse aid is
not sufficient. Adjust the rinse aid level to a higher
level.
• Plastic items may need to be towel dried.
• For the best drying performance, activate XtraDry
and AirDry.
• We recommend to always use rinse aid, even in
combination with multi-tablets.
There are whitish streaks or
bluish layers on glasses and
dishes.
• The released quantity of rinse aid is too high. Ad‐
just the rinse aid level to a lower level.
• The quantity of detergent is too high.
There are stains and dry wa‐
ter drops on glasses and
dishes.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
www.electrolux.com22
