How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
,
and start to flash and the display is
blank.
2. Press Program.
• The indicators
and
go off.
• The indicator continues to
flash.
• The display shows the current
setting: e.g.
= level 5.
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm the
setting.
7.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
Use of rinse aid and multi-tablets
together
When you activate the option Multitab, the
rinse aid dispenser no longer releases
rinse aid. However if you are using multi-
tablets and the drying results are not
satisfactory, we suggest to use multi-
tablets and rinse aid together. In this case
you have to activate the rinse aid
dispenser.
The rinse aid dispenser will remain
activated until you modify the setting again
How to activate the rinse aid
dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators ,
and start to flash and the display is
blank.
2. Press Option.
• The indicators and go
off.
• The indicator continues
to flash.
• The display shows the current
setting.
– = rinse aid dispenser
deactivated.
– = rinse aid dispenser
activated.
3. Press Option to change the setting.
4. Press the on/off button to confirm the
setting.
5. Adjust the dosage of rinse aid.
6. Fill the rinse aid dispenser.
7.4 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to activate
it.
How to activate the acoustic
signal for the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and
hold simultaneously Delay and Start
until the indicators ,
and start to flash and the display is
blank.
2. Press Delay
• The indicators and
go off.
• The indicator continues to flash.
• The display shows the current
setting:
– = Acoustic signal off.
www.electrolux.com10
