Upper basket
cup racks: position A
Installation
Any electrical and/or plumbing work
required to install this appliance should
be carried out by a qualified electrician
and/or plumber or competent person.
Remove all packaging before positioning the
machine.
If possible, position the machine next to a
water tap and a drain.
Fitting under a counter (kitchen worktop
or sink)
By removing the machine’s worktop, you can
install it under a close fitting sink unit or a pre-
existing top, providing the dimensions of the
recess correspond to those shown in the
picture.
Proceed as follows:
• Remove the machine’s worktop by un-
screwing the two rear retaining screws,
pull the worktop from the back of the ma-
chine and slide out the front slots, lifting the
worktop.
• Insert the machine after adjusting the lev-
elling with the adjustable feet.
When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or
squashed.
During all operations that involve accessibility
to internal components the dishwasher has
to be unplugged.
Be sure that once the appliance has been in-
stalled, it is easily accessible for the service
engineer in the event that a repair is required.
If the dishwasher is later used as a free-
standing appliance, the original worktop
must be re-mounted.
The plinth on free-standing appliances is not
adjustable.
Levelling
Good levelling is essential for correct closure
and sealing of the door. When the appliance
is correctly levelled, the door will not catch on
either side of the cabinet. If the door does not
close correctly, loosen or tighten the adjust-
able feet until the machine is perfectly level.
18 electrolux
