Dil ID: 9
Dil Adı: germany
Dil Kodu: de1tayfun Produkte der Marke Electrolux
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Problem Possible solution
The appliance does not drain the
water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.
The anti-flood device is on. Close the water tap and contact the Service.
After the checks are completed, turn the
programme knob until the programme
marker is aligned with programme that
was in operation when the problem oc-
curred. The programme continues from
the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes show, contact the
Service.
9.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
The quantity of detergent is too much.
Stains and dry water drops on
glasses and dishes
The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
The quality of the detergent can be the
cause.
Dishes are wet
The programme is without a drying
phase or with a low temperature drying
phase.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
10. TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 600 / 850 / 625
Electrical connection Refer to the rating plate.
Voltage 220 - 240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity Place settings 12
Power consumption Left-on mode 0.50 W
Off-mode 0.50 W
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
2)
If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
ENGLISH 15