the right to suit the installation by means of
the locknut. The locknut must be
correctly fitted to avoid water leaks.
Attention! NOT all models of dishwash-
ers have inlet and drain hoses provided
with a locknut. In this case, this facility is
not available.
If the machine is connected to new pipes or
pipes which have not been used for a long
time, you should run the water for a few mi-
nutes before connecting the inlet hose.
DO NOT use connection hoses which
have previously been used on an old ap-
pliance.
This appliance has been fitted with
safety features which will prevent the
water used in the appliance from return-
ing back into the drinking water system.
This appliance complies with the appli-
cable plumbing regulations.
Water inlet hose with safety valve
After connecting the double-walled water in-
let hose, the safety valve is next to the tap.
Therefore the water inlet hose is only under
pressure while the water is running. If the wa-
ter inlet hose starts to leak during this opera-
tion, the safety valve cuts off the running
water.
Please take care when installing the water
inlet hose:
• The electrical cable for the safety valve is
in the double-walled water inlet hose. Do
not immerse the water inlet hose or the
safety valve in water.
• If water inlet hose or the safety valve is
damaged, remove the mains plug
immediately.
• A water inlet hose with safety valve must
only be replaced by the Service Force
Centre.
Warning! Dangerous voltage
Water drain connection
The end of the drain hose can be connected
in the following ways:
1. To the sink outlet spigot, securing it to the
underside of the work surface. This will
prevent waste water from the sink run-
ning into the machine.
2. To a stand pipe provided with venthole,
minimum internal diameter 4 cm.
The waste connection must be at a height of
between 30 cm (minimum) and 100 cm
(maximum) from the bottom of the
dishwasher.
The drain hose can face either to the right or
left of the dishwasher
Ensure the drain hose is not bent or
squashed as this could prevent or slow down
the discharge of water.
The sink plug must not be in place when the
machine is draining as this could cause the
water to syphon back into the machine.
If you use a drain hose extension it must be
no longer than 2 metres and its internal
diameter must be no smaller than the diame-
ter of the hose provided.
Likewise the internal diameter of the cou-
plings used for connections to the waste
outlet must be no smaller than the diameter
of the hose provided.
When connecting the drain hose to an under
sink trap spigot, the entire plastic mem-
brane (A) must be removed. Failure to re-
move all the membrane will result in food
particles building up over time eventually
blocking the dishwasher drain hose spigot
electrolux 21
