AB
2. To remove the coarse filter (C), hold
tightly the fine filter (B) and press the
two sides of the coarse filter (C).
3. Pull the coarse filter (C) out of the fine fil-
ter (B).
C
B
4. Fully wash the two filters with water and
a brush.
5. Remove the main filter (A) and fully wash
it with water.
6. Put the main filter (A) in its initial posi-
tion. Make sure that it assembles cor-
rectly.
7. Put the fine coarse filter (C) in the fine fil-
ter (B). Make sure that they assemble
correctly in each other.
8. Put the fine filter (B) in the main filter (A)
and turn it clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (e.g. acetone).
WHAT TO DO IF…
The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
With some malfunctions, alarm codes
show:
The indicator of the washing programme ‘Rinse
& Hold’ flashes very quickly.
An intermittent acoustic signal operates for ap-
proximately 30 seconds.
The appliance does not fill with water.
The indicator of the washing programme ‘Deli-
cate 45°’ flashes very quickly.
An intermittent acoustic signal operates for ap-
proximately 30 seconds.
The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Problem Possible cause Possible solution
The washing programme does
not start.
The mains plug is not connec-
ted in the mains socket.
Connect the mains plug.
electrolux 11
