Hard-Disk Drive Removal
To remove a hard-disk drive, perform the following steps.
1. Remove the computer cover.
2. Remove the front panel.
3. Disconnect the DC power and data cables from the rear of the drive.
4. Lift the drive door handle and open the drive door until it disengages from the hard-disk drive bracket (see Figure13).
5. Use two hands to pull the hard-disk drive bracket completely out of the chassis.
Figure 13. Hard-Disk Drive Bracket Removal
Hard-Disk Drive Installation
To install a hard-disk drive, perform the following steps:
1. Slide the drive into the chosen bay of the hard-disk drive bracket, oriented so that the connectors on the back of the drive will face the back of
the chassis when the hard-disk drive bracket is reinstalled (see Figure14).
2. Align the four screw holes of the drive and hard-disk drive bracket. Insert and tighten the screws (see Figure 14).
Figure 14. Inserting a Hard-Disk Drive in the Hard-Disk Drive Bracket
