Back to Contents Page
Coin-Cell Battery
Dell™Inspiron™410ServiceManual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery
Removing the Coin-Cell Battery
1. Record all the screens in the system setup utility (see System Setup Utility) so that you can restore the correct settings after the new coin-cell battery
has been installed.
2. Follow the procedures in Before You Begin.
3. Remove the top cover (see Removing the Top Cover).
4. Remove the top bracket (see Removing the Top Bracket).
5. Remove the optical drive (see Removing the Optical Drive).
6. Remove the drive bay (see Removing the Drive Bay).
7. Locate the coin-cell battery socket (see System Board Components).
8. Carefully pull the release lever away from the coin-cell battery and lift the coin-cell battery out of the socket.
Replacing the Coin-Cell Battery
1. Follow the procedures in Before You Begin.
2. Insert the new coin-cell battery into the socket with the side labeled "+" facing left.
3. Replace the drive bay (see Replacing the Drive Bay).
4. Replace the optical drive (see Replacing the Optical Drive).
5. Replace the top bracket (see Replacing the Top Bracket).
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
