11
InstallatIon InstructIons
To attach the anti-tip bracket anchors, insert the
anchoring screws through the 1/2” diameter access
holes inside the dishwashing compartment on the
ceiling and the sides, near the front. Make sure that the
anchoring screws pass through the anti-tip brackets
located on the outside of the dishwasher.
Cabinet Panel Installation (Model ID24 Only)
Install the custom panel according to the instructions
on the included template (part# 101394). If the panel
requires decorative door hardware, attach it before panel
installation.
WARNING
The provided mounting screws are designed for
panels with a thickness of 5/8” to 3/4”. Smaller panels
may require different mounting hardware to prevent
damage to the outside surface.
To prevent corrosion and the possibility of the panel
falling off, use only stainless steel screws where
instructed.
•
•
2.
InstallIng the unIt In the
caBInet
Slide the Dishwasher into the Cut-out
Pull the electrical wiring and both hoses (drain and
water supply) through the utility access hole in the side
of the cabinet as you slide the dishwasher into the
opening. Stop when the dishwasher contacts the back
wall or aligns with the front cabinet opening.
Install the Anti-Tip Brackets
CAUTION
Make sure to anchor at least one anti-tip bracket on
each side of the dishwasher.
The anchoring material must be no more than 1/4” (6
mm) from the anti-tip bracket.
•
•
The anti-tip brackets protect against possible tipping
caused by heavy bottom rack loads on the door.
There are anti-tip mounting locations provided around
the top and sides of the dishwasher front frame.
•
1.
Side anti-tip
bracket
Top anti-tip
bracket
NOTE: The leg nuts can be removed to make the
dishwasher lower. To do so:
Turn the leg until it comes out of the chassis.
Remove the nut from the leg.
Re-thread the leg into the chassis.
Reach inside the chassis and thread the nut onto
the top of the leg.
◊
◊
◊
◊
CUSTOM PANEL
INSTALLATION
(ID24 ONLY)
(continued)
