Dil ID: 9
Dil Adı: germany
Dil Kodu: de2tayfun Produkte der Marke Bosch
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



12
Washing programmes*
* depends on the model
Clinic Wash ;
For washing fabrics with increased hygiene requirements or those that will
be used by allergy sufferers. The temperature remains constant during the
washing process. More intensive rinsing with increased water level. For
hard-wearing and easy-care fabrics made from cotton or linen.
Nocturno (Night Wash)
Particularly quiet wash programme with a reduced final spin.
Sleep mode. Once the programme has finished, the display goes out, but
can be reactivated by pressing any button.
Drying programmes
Secar Normal (Intensive Dry)
Intensive drying for a (robust fabrics), at 90°C.
Secar Suave (Gentle Dry)
Gentle drying for ` (easy-care fabrics), 60°C.
Special programmes
limp. pelusas/fios (Fluff removal cycle)
This programme is designed to clean the drying cycle of any fluff
deposits. After 10 drying cycles, the washer-dryer uses the symbol
l (Fluff removal cycle) in the display panel to show that this programme
should be run. The electronic cycle counter is then automatically reset.
The
l (Fluff removal cycle) symbol goes out after the programme starts.
To run the limp. pelusas/fios (Fluff removal cycle), proceed as follows:
Make sure that the drum is completely empty and close the door.
Turn the programme selector to
l (Fluff removal cycle).
Press the A (Start/Pause) button.
The limp. pelusas/fios (Fluff removal cycle) programme can also be run
at any time without prompting by the appliance.
' + B Rinse + Spin:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the Spin speed to $ (Rinse hold) before Programme
start –> page13.
[ + B Empty + Spin:
Drain the rinsing water following a programme with
$ (Rinse hold) –> page13.
Turn the programme selector to [ + B Empty + Spin.
Set the spin speed to $ (Rinse hold).
Press the A (Start/Pause) button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to [ + B Empty + Spin.
Press the B button repeatedly until the desired spin speed is set.
Press the A (Start/Pause) button.
i
Downloaded From WashingMachine-Manual.com Manuals