\
s
OL0866
STOP
Si
02»
KJ
STOP
OL0870
Clearing Debris & Blockages
ALWAYS disengage Impeller, stop
engine, remove key and wait for all
moving parts to stop before you: leave
operators position, unclog unit, make
repairs or adjustments or inspections.
Check for and repair any damage
before restart.
Run unit a few minutes after throwing
snow to prevent freeze-up of Impeller.
Electric Starter
Use only approved extension cords and
receptacles when starting units
equipped with Electric Starter.
Maintenance and
Service Safety
Abnormal Vibrations
Stop unit and engine immediately,
remove key and wait for all moving
parts to stop. Check for and repair any
damage before restart. Check for and
tighten any loose hardware before
restart.
Parking
Never leave a running unit unattended.
ALWAYS shut off engine.
ALWAYS remove key to prevent
unauthorized use when unit is not in
operation.
Si
K.0610
_________
^
Engine
Before maintenance, adjustments or
service (except where specifically
recommended):
Shut off engine
Ol
Allow engine to cool
Transport
Disengage Impeller, and shut off engine
when unit is being transported.
Safety Devices
NEVER operate unit without guards
and other safety devices in place and
functional.
Check Clutch and Brake function
frequently as instructed in Assembly
Section.
Storage
NEVER store unit, with fuel in fuel tank,
inside a building where ignition sources
(pilot lights, hot water or space heaters,
clothes dryers, etc.) are present.
Allow engine to cool before storage in
any enclosure.
If storing for an extended period, clean
unit thoroughly and see Engine Manual
for proper storage.
Ariens* Sno-Thro* Orig. 4/96
