Appendix A: Printer Status
Printer is paused. Press PAUSE or CANCEL to
return to normal.
Media is uninstalled or used up. Load new
media to the printer.
Ribbon is uninstalled or end-of-ribbon occurred.
Load new ribbon to the printer.
Format or baud rate of RS232 communication is
inconsistent between printer and host.
Cutter cannot cut off the media, check media
and cutter.
Printer buffer full due to loaded soft fonts,
graphics or forms. Check data format. Call for
service.
Print head latch is not closed. To print label the
head latch must be closed.
Media sensor is out of range during calibration.
Make sure the media is installed and the label
sensor is under the media.
Printing job will start until the temperature of
TPH goes down.
