3. Configuration
AirLive WN-220ARM User’s Manual 50
7. User Rule#: The QoS rule can work with Scheduling Rule number#. Please refer to the
Section 3.4.1.7 Schedule Rule.
Afterwards, Click on “Save” to store your settings or click “Undo” to give up the changes.
3.5.4 SNMP
In brief, SNMP, the Simple Network Management Protocol, is a protocol designed to give a
user the capability to remotely manage a computer network by polling and setting terminal
values and monitoring network events.
1. Enable SNMP: You must check “Local”, “Remote” or both to enable SNMP function. If
“Local” is checked, this device will respond request from LAN. If “Remote” is checked,
this device will respond request from WAN.
2. Get Community: The community of GetRequest is that this device will respond.
3. Set Community: The community of SetRequest is that this device will accept.
4. IP 1, IP 2, IP 3, IP 4: Enter the IP addresses of your SNMP Management PCs. User has
to configure where this device should send SNMP Trap message.
