Problem Possible cause Solution
Products prevent that wa-
ter flows into the water
collector.
Make sure that products
do not touch the rear
plate.
Water flows on the
ground.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low.
The temperature regula-
tor is not set correctly.
Set a higher temperature.
The temperature in
the appliance is too
high.
The temperature regula-
tor is not set correctly.
Set a lower temperature.
Many products are stored
at the same time.
Store less products at the
same time.
The temperature in
the refrigerator is
too high.
There is no cold air circu-
lation in the appliance.
Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too
high.
Products are too near to
each other.
Store products so that
there is cold air circulation.
6.1 Replacing the lamp
1
2
1.
Switch off the appliance.
2.
Press on the rear hook and at the
same time slide the cover in the di-
rection of the arrow.
3.
Replace the lamp with one of the
same power and specifically de-
signed for household appliances.
(the maximum power is shown on
the lamp cover).
4.
Slide the lamp cover into its original
position.
5.
Switch on the appliance.
6.
Open the door. Make sure that the
light comes on.
6.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
12
www.aeg.com
