Moving the machine
If you have to move the machine (moving house etc....):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge hoses.
4. Pull the machine out together with the hoses.
Avoid over tilting the machine during transportation.
What to do if…
The dishwasher will not start or stops during operation. Certain problems are due to the
lack of simple maintenance or oversights, which can be solved with the help of the indi-
cations described in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the following suggested corrective actions.
Fault code and malfunction Possible cause and solution
•
continuous flashing of the START/RESET in-
dicator light
•
1 flash of the end of programme indicator
light
The dishwasher does not fill with water
• The water tap is blocked or furred with lime-
scale
Clean the water tap
• The water tap is turned off
Turn the water tap on
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked
Clean the filter in the threaded hose
• The water inlet hose has not been correctly
laid or it is bent or squashed
Check the water inlet hose connection
•
continuous flashing of the START/RESET in-
dicator light
•
2 flashes of the end of programme indica-
tor light
The dishwasher will not drain
• The sink spigot is blocked
Clean out the sink spigot
• The water drain hose has not been correctly
laid or it is bent or squashed
Check the water drain hose connection
•
continuous flashing of the START/RESET in-
dicator light
•
3 flashes of the end of programme indica-
tor light
• Anti-flood device is activated
Close the water tap and contact your local Serv-
ice Force Center.
• The programme does not start • The dishwasher’s door has not been properly
closed
Close the door
• The main plug is not plugged in
Insert the main plug
• The fuse has blown out in the household fuse
box
Replace the fuse
• Delay start has been set
If dishes are to be washed immediately, cancel
the delay start
20
What to do if…
