2-2
Chapter 2
Programming Procedures
318: DISTINCTIVE RING 708: ACCOUNT CODE
319: BRANCH GROUP 709: TOLL PASS CODE
400: CUSTOMER ON/OFF PER TRUNK 710: LCR DIGIT TABLE
711: LCR TIME TABLE 736:
ASSIGN AA MOH
712: LCR ROUTE TABLE 740: STATION PAIR
713: LCR MODIFY DIGIT TABLE 750: VMS RESTART
714: DID NUMBER & NAME TRANSLATION 751: ASSIGN MAILBOX
715: PROGRAMMED STATION MESSAGE 752: AUTO RECORD
716: UK LCR OPTION 753: WARNING DESTINATION
718: MY AREA CODE 754: VM HALT
720: COPY KEY PROGRAMMING 755: VM ALARM
721: SAVE STATION KEYPROGRAMMING 756: ASSIGN VM MOH
722: Station Key Programming 757 VM IN/OUT
723: System Key Programming 800: Enable Technician Program
724: DIAL NUMBERING PLAN 801: CHANGE TECHNICIAN PASSCODE
725: SMDR Options 802: CUSTOMER ACCESS MMC NUMBER
726: VM/AA Options 804: SYSTEM I/O PARAMETER
727: SYSTEM VERSION DISPLAY 805: TX LEVEL & GAIN
728: CLIP TRANSLATION TABLE 806: CARD PRE–INSTALL
730: AA RECORD GAIN 807: VOLUME CONTROL
731: AA RAM CLEAR 809: SYSTEM MMC LANGUAGE
732: AA TRANS TABLE 810: HALT PROCESSING
733:
AA PLAN TABLE
811: RESET SYSTEM
734:
AA MESSAGE MATCH
812: COUNTRY CODE
735:
AA USE TABLE
PROGRAM PROCEDURES
The instructions for each MMC assume that you have already opened programming. First, run MMC 812,
Country Code, to set your country (e.g U.K.) before you do any other programming.
This manual describes standard settings. Some MMC codes and default data may be different
from those shown depending on the country selected in MMC 812.
Helpful hint:
When you are finished programming in MMC codes 100–812 and have other programming to do, press SPK
to exit the MMC but stay in the programming mode and use one of the following methods.
1.Dial another MMC code directly and continue programming.
2.Press VOLUME UP and DOWN keys to scroll through all MMC codes. When the desired MMC code is
reached, press SPK and continue programming.
Pressing TRSF will always save changes and exit programming mode.
CAUTION
Technical Manuals Online! - http://www.tech-man.com
