3
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the telephone
base or charger when not in use. The battery is fully charged after 11 hours of
continuous charging.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger
and ashes.
The battery has no or very little
charge. The handset cannot
be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and ashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
If you place the handset in the telephone base or charger without plugging in the
battery, the screen displays NO BATTERY.
Add and register a handset
This telephone system accommodates up to ve handsets. You can add new
handsets (DS6701, purchased separately) to your telephone system. Each handset
must be registered with the telephone base before use. Additional handsets
registered to the telephone base are assigned numbers in the sequential order.
When rst purchased and properly charged, each expansion handset shows
To register HS... and ...see manual alternately. Charge the handset before
registering it to the telephone base.
To register a handset:
Place the new/non-registered handset in the telephone base.
Both the telephone base and the handset show Registering... Then both
devices show Registered and you hear a beep when the registration process
completes. The registration process takes about 60 seconds to complete.
Deregister handsets
If you want to replace a handset or reassign the designated handset number of a
registered handset, you must deregister all handsets and then individually register
each handset.
Remove any handset put in the telephone base before deregistration.
To deregister all handsets:
Press and hold FIND HANDSET on the telephone base for about 10 seconds
until the telephone base shows Registering... then De-register?
Immediately press and release MENU/SELECT or FIND HANDSET. The
telephone base displays Please wait.
All handsets show To register HS... and ...see manual alternately when the
deregistration process completes. The deregistration process takes about
10 seconds to complete.
1.
2.
1.
2.
3.
Do not place the handset
in the charger.
