03
LED LENSER® * SEO 3
SEO 3 blinks in the Light Function Signal (slow
even flashing).
The Light Function Signal is the last Light
Function that can be used in the Light Program
“Red Night Vision” so additional switching turns
SEO 3 off and the circle starts again with the
Light Function Power when you press the switch
button again.
So the Light Functions are in a loop. But please
note that you turn off the head lamp by every
switching if since the previous switching more
than 2 seconds have elapsed. For example in
case you let pass more than 2 seconds after
you turned the Light Function Power on the next
switching will not change to head lamp to Light
Function Signal but will turn the SEO 3 off.
6. “Transport Lock”
Under Point 5 it has been described how to
switch between the white and the red LED.
This takes place when the SEO 3 is off and the
switch button is pressed only for approx. 2
seconds. The head lamp will change from red
to white or from white to red. But when the
switch is pressed longer (approx. 5 seconds)
until the light turns off you have enabled the
“Transport Lock”. Then the SEO 3 can not be
turned on again but the red LED flashes for a
short moment to indicate that this function is
activated in case the switch button is pressed.
The SEO 3 therefore cannot be switched on,
either intentionally or unintentionally and
inadvertently consume energy.
Only when you hold the switch button pressed
for 5 seconds again this function (“Transport
Lock”) is deactivated again and the lamp is in
the Light Program White.
7. Reset function
If the used alkaline batteries are taken out the
battery box you have "reset" the SEO 3. You
have thus reset two functions:
- The “Transport Lock” (s. Point 6) is deactivated
- The Light Program White (s. Point 5) is activated
8. Use of rechargeable batteries
Only use 3 x Alkaline battery AAA/LR03/Micro
(1.5 V DC) or 3 x NiMH-Accumulator AAA/LR03/
Micro (1.2 V DC) in your SEO 3. Please change
all alkaline batteries respectively rechargeable
batteries (i.e. accumulators) in time.
The scope of delivery of the SEO 3 includes
alkaline batteries. This type of battery cannot
be charged resp. recharged.
9. Changing of the batteries / accumulators
Prior to the change, please turn off the SEO 3.
On the wide side of the head lamp housing is
the cover of the battery box. Nearby the switch
button there is a plastic lip. If this lip is carefully
pressed a little with e.g. your thumb up a little,
the battery box cover can be folded down by
using the small notches that are to the left and
the right of the switch button.
You can now remove the Alkaline batteries
respectively NiMH-Accumulator and insert new
ones.
During insertion, it is vital the batteries point
in the right direction. Therefore, pay attention
to the polarities (+ and -). Both in the battery
box and also on the batteries / accumulators.
Otherwise, the hypothetical risk that batteries or
accumulators are damaged and may explode.
After replacing the cover of the battery box has
to be closed again.
Note – Please ensure that there is no short-
circuit at the contacts of the batteries. The
contacts of the batteries may not be touched
with moist or metallic objects.
10. Headband
If the headband is not already connected to the
lamp unit, proceed as follows.
Thread the end of headband with the narrow
plastic part from the front through the eyelet
on the left side of the head lamp housing.
Note the orientation of the lettering on the
headband. Run the headband then over the
cover of the battery box to the eyelet on the
other side of the battery box and run it through
it to the front.
This end of the headband has got to be pulled
through the hole beside the clipper at the
plastic part on the other side of the headband.
This elongate hole has got 4 small bars
through which the narrow plastic part has to
be run from the side.
This allows that the complete end is pulled
through this hole and both ends of the
headband are connected to each other.
By using the eye of the clipper the SEO 3 can e.g.
attached to an ear of a belt or a backpack for
transportation.
The third plastic component at the headband
can be used to adjust the length of the
headband in order to fit different head
circumferences.
11. Rechargeable batteries / Accumulators
Non rechargeable batteries (e.g. Alkaline
batteries) are not allowed to be charged.
Never use non rechargeable batteries and
accumulators together. Change always all
batteries / accumulators at the same time. Use
in the SEO 3 only Alkaline batteries AAA/LR03/
Micro (1.5 V DC) or NiMH-Accumulators AAA/
LR03/Micro (1.2 V DC).
If you intend not to use the item for an
extended period, please take out the batteries
respectively the accumulators in order to avoid
damage.
Discharged batteries (or accumulators – when
they can’t be recharged any longer) have to be
taken out of the product and properly disposed
with regards to the national laws.
In general, for the disposal of batteries as
well as particularly for Lithium batteries,
accumulators and accumulator packs, the
applicable rule is that they may only be
disposed of in discharged state and in a
technically correct manner. Additionally before
disposal it has to be ensured, by sticking non-
conducting adhesive tape over the contacts
that short-circuits are not possible.
Basically, the possibility of short-circuits of
batteries and also accumulators must be
eliminated and they may neither be opened,
nor enter the human body in any way, nor may
they be thrown into a fire.
12. Cleaning
For cleaning, please use a dry, lint-free, clean cloth.
If salt water is spilled on the head lamp, it must be
immediately entirely removed with such a cloth.
The headband can be washed in a washing machine
at 30 °C.
