21
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that they
can be refitted if the machine ever has to be transport-
ed again.
1. Using a spanner, unscrew and remove the two rear
bottom screws. Slide out the two plastic pins. Lay
the machine on its back, taking care not to squash
the hoses. This can be avoided by placing one of
the corner packing pieces between the machine
and the floor.
2. Remove the polystyrene block from the bottom of
the machine and release the two plastic bags.
3. Very carefully slide out the left polythene bag,
removing it towards the right and then downwards.
4. Very carefully slide out the right polythene bag,
removing it towards the left and then upwards.
5. Set the machine upright and remove the remaining
rear screw. Slide out the relevant pin.
6. Plug all the holes with the plugs which you will find
in the envelope containing the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar materials
under the machine to compensate for any unevenness
in the floor.
Water inlet
Connect the water inlet hose supplied with the
machine to a tap with a 3/4" thread.
Do not use already employed hoses.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to
purchase a new, longer hose specially designed for
this type of use.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply loosen
the fitting, rotate the hose and retighten the fitting,
making sure there are no water leaks.
