26
ENGINE
ENGINE TIGHTENING TORQUES
8 Crankshaft bearing
NOTE: Maximum length under heads for M11 = 131,5 mm.
NOTE: Maximum length under heads for M8 = 119 mm.
Perform the following operations:
- Brush the screw threads.
- Refit the screws having first pre-coated them with «MOLYKOTE G RAPID PLUS» grease
on the threads and under heads.
Check the presence of the eight centring pins
Pre-tighten the screws M11 (sequence from 1 to 8) 3 ± 0,3
Pre-tighten the screws M8 (sequence from A to H) 1 ± 0,1
Tighten the screws M6 (sequence from a to 1) 1 ± 0,1
Slacken the screws screws M11 and M8 Yes
Proceeding screw by screw
Tighten the screws M11 (sequence from 1 to 8) 3 ± 0,3
Angular tightening 180°
Tighten the screws M8 (sequence from A to H) 1 ± 0,1
Angular tightening 180°
Engine: ES9A
B1BP2D3D
Angl-C6-page022-82-2005 4/02/05 17:19 Page 26
