201
HYDRAULICS
DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUIT
Tools.
[1] PROXIA station : 4165-T
[2] LEXIA station : 4171-T
De-pressurisation.
NOTE: It is possible to de-pressurise the suspension by individual axle.
Using a diagnostic tool.
Start the engine.
Place the height control in the «LOW» position.
Wait for the vehicle height to reach the position required.
Stop the engine.
Connect the diagnostic tool [1] or [2] to the vehicle's diagnostic socket.
Switch on the ignition.
Carry out a global test.
Go into the menu:
- Suspension.
- De-pressurisation.
Follow the instructions displayed on the screen.
Wait for the vehicle's suspension to sink completely.
NOTE: This operation takes around 3 minutes.
Switch off the ignition.
Disconnect the battery.
Without a diagnostic tool.
IMPERATIVE: Any LDS fluid that is collected must not be re-used.
NOTE: Collect the LDS fluid in order to keep the work area clean.
Respect the environment.
Start the engine.
Place the height control in the «LOW» position.
Stop the engine.
Angl-C6-page195-202-2005 4/02/05 17:36 Page 201
