10 Introduction
e RESET button
Push the button more than 3 seconds, this would restore the factory default settings.
f RS-485/RS-422 Dip Switch
The default position of the dip switch and function are as shown below.
Position SW1 SW2 SW3 SW4
ON RS485 RS485 HALF TERMINATION ON
OFF RS422 RS485 FULL TERMINATION OFF
g VIDEO OUT
Supplies analog video signal (composite) to the connected device.
h AUDIO OUT (Line Level Output)
Connect to an active speaker with a built-in amplifier.
i AUDIO IN (Line Level Input)
Input for a mono microphone, or a line-in mono signal.
j ETHERNET/POE Port
Connects to a PC or a network via a hub with a 10BASE-T/100BASE-TX cable attached RJ-45 connector.
Note:
Power over Ethernet (PoE) is a technology that integrates power into a standard LAN infrastructure. It enables power to be provided
to the network device, such as a network camera, using the same cable as that used for network connection. It eliminates the need
for power outlets at the device locations and enables easier application of uninterruptible power supplies (UPS).
k Power input terminal
Connects to a DC 12V or AC 24 V power supply using proper cables.
