620
Replacement of Tires
Exchange tires
620
In case of replacing the tire, use a tire of
the same specification and model with
the replaced one and whose carrying
capacity is equal to or larger than that of
a common one.
Use of a tire of any other model will cause a
serious impact to the vehicle driving and
riding, calibration of the speedometer/
odometer, ground clearance and the
space between the vehicle body and the
tire or the tire chain.
Warning
Follow the instructions below; otherwise,
a serious injury or even death will be
caused.
●Radial tire, bias belted tire and
diagonal-ply tire can not be mixed in a
vehicle; otherwise a typical operation
danger will be resulted in and then
cause the vehicle to lose control.
●Do not use any tire with a size not
recommended by Lifan; otherwise a
typical operation danger will be resulted
in and then cause the vehicle to lose
control.
No using any old tire on LF620.
It is very dangerous to use tires without
clear identification.
You are advised to replace the four tires
at the same time, or two front tires or two
rear ones at least.
Refer to “If the Tire Leaks”in Chapter
4 for steps of tire replacement.
Keep the wheels balanced when replacing
tires.
Unbalanced wheels wi ll effect the vehicle
operation and the service life of the tires.
The wheels ma y loose balance in case of a
normal use. Therefore, carry out a regular
check-up to keep them balanced.
The air valves must be replaced with new
ones in case of a tire replacement.
You are recommended to exchange the
tires after each mileage of 10,000km so
as to maintain the same wear of the
tires and extend their service life.
However, the proper time for that should
be determined according to the habit of
the driver and also the road conditions.
Refer to “If the Tire Leaks”in Chapter
4 for steps of tire replacement.
Check if there is uneven wear and damage
on the tires when exchanging them. The tire
will be abnormally worn due to the incorrect
tire pressure, improper wheel alignment and
unbalanced wheel or frequent braking.
Install tire chain
Selection of tire chain
Use the tire chain of correct size.
The use rules of tire chain will change
according to different places or roads,
therefore, make sure the local rules
before installing the tire chain.
Installation of tire chain
Try to install the tire chain at the front
tires as tight as possible. Don't use
tire chains at rear tires. After driving
for 0.5～1.0km, tighten the tire chain
again.
When installing the tire chain to the tire,
be careful to abide by the guidance of
the tire chain manufacturer.
When the wheel house is used, it may
be scratched by the tire chain, so it is
necessary to take off the wheel house
before installing the tire chain.
Warning
●When using tire chain, the driving
speed should not exceed 50km/h or
the lower speed limit specified by the
tire chain manufacturer.
●When using tire chain, be careful in
driving to note the ridge, hole and
sharp turn of the road, which may
result in the jump of car.
●When using tire chain, avoid sudden
turn or wheel lock brake, which may
bring about bad effect to the operation
of the car.
●When the car is installed with tire
chain, the driver should be careful to
decelerate before making a turn, for
avoiding losing the control over the
car, or accident will occur.
16 1
16 2
Instru cti on Manual of Lifan Sedan
LIFAN
Instru cti on Manual of Lifan Sedan
Instru cti on Manual of Lifan Sedan
LIFAN
Chongqing Lifan Passenger Vehicle Co., Ltd.
Chongqing Lifan Passenger Vehicle Co., Ltd.
