39
Figure 22: Fuse box and relay location
Fuse colours
The fuses are colour coded to identify their amperage
ratings as follows:
ORANGE 5 amp
BROWN 7.5 amp
RED 10 amp
BLUE 15 amp
YELLOW 20 amp
CLEAR 25 amp
GREEN 30 amp
Parts & Accessories
Service parts & accessories
Only Caterham Cars and their dealers are able to
provide the full range of recommended parts and
accessories which meet our rigorous standards of
safety, durability and performance.
To ensure your future driving pleasure and safety, we
strongly recommend that only Caterham approved
parts are fitted to your car.
All genuine Caterham parts and accessories are
guaranteed for twelve months or 6000 miles
(whichever is sooner) with unlimited mileage.
A comprehensive parts resource is available from
Caterham Parts Department or via our online part store
at www.caterhamparts.co.uk
Fitment of non-Caterham approved parts could affect
the resale value of your car.
WARNING!
It is extremely hazardous to fit parts or
accessories where installation requires the
dismantling of, or addition to, either the electrical
or fuel systems.
Fitting parts or accessories that have not been
approved by Caterham, or the carrying out of
non-approved alterations or conversions, may be
dangerous and could affect the safety of the car
and occupants, and also invalidate the terms and
conditions of the car’s warranty.
Bulb Replacement
1. Headlamps
Loosen the screw on top of the headlamp bowl until the
rim with the light attached can be unclipped and pulled
free. The wiring is released from the back of the lamp
unit by pulling off the plastic connection. The bulbs can
be changed by removing the rubber dust cover then
squeezing the retaining clip to release the bulb itself.
Care should be taken not to touch the Halogen bulb
glass as this may cause it to blow on first use.
2. Side lamp (front)
First release headlamps as above. Sidelamps are
connected separately into the back of the headlamp
and pull free to enable bulb changing. The side lamp
bulb is a capless bulb and can be removed by pulling it
straight out of its holder.
3. Indicators (front)
Remove the two screws holding the lens in place. The
bulb can then be removed and the new one refitted by
Pushing and turning through 45°.
4. Indicator repeaters (front)
Remove the single screw holding the lens and unclip.
The bulb can then be removed and the new one
refitted by pushing and turning through 45°.
5. Stop/tail and indicators (rear)
The lenses are held in place by two screws which allow
the complete lens to be removed for access. The bulbs
can then be removed and the new ones refitted by
pushing and turning through 45°.
6. Rear fog light, reversing light
The lenses are held in place by two screws which allow
the lens to be removed for access. The bulbs can then
be removed and the new ones refitted by pushing and
turning through 45°. When refitting the lens ensure that
the rubber seal is fitted correctly to prevent water
ingress.
