ECLIPSE Service Manual Carefree of Colorado
28 052547-301r6
STANDARD SERVICE PROCEDURES
PROGRAMMING THE REMOTE RECEIVER
Early transmitters & receivers operate on a frequency of 418MHz.
Models for 2007 & on operate on 433MHz. The transmitter and receiver
frequencies must match. Identifying the transmitter frequency is
described under the operational notes below.
1. Power to the control box must be on.
2. Press and release the “Press to Learn Transmitter” button on the
bottom of the receiver box. The receiver is in program mode when
the red light comes on.
3. For Gray Button Key FOBS:
Press and release ANY button on the
remote. It is recommended to use the STOP button. The red light
will go out after the receiver learns the remote signal.
CAUTION
WHEN THE RECEIVER LEARNS THE TRANSMITTER SIGNAL, THE SYSTEM WILL PERFORM THE OPERATION OF THE
BUTTON PRESSED
. EXAMPLE: PRESSING AN "EXTEND" BUTTON DURING THE LEARNING PHASE WILL CAUSE THE
AWNING TO EXTEND WHEN THE RECEIVER LEARNS THE SIGNAL
. USE CAUTION TO AVOID UNEXPECTED MOVEMENT
BY THE AWNING
.
4. For Key FOBS w/ Antenna:
Press and release the STOP button on the remote. The red light will go
out after the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to default as the close
(retract) function. If a function button is pressed to train the receiver, it will be programmed as
the close (retract) button. Example: Pressing the bottom button will program the bottom button
for retract and the top button as extend.
5. Repeat for each additional remote.
Operational Notes:
1. Transmitter and receiver must match in
frequency (418 MHz or 433 MHz).
1.1. Key FOBS:
1.1.1. The gray button key FOBS
are marked with a label for
418 MHz or 433 MHz.
1.1.2. Key FOBS w/ antenna are
433 Mhz
1.2. Receivers
1.2.1. 418 MHz receivers are
marked "RR24".
1.2.2. 433 MHz receivers marked
"RR" Version 1 can only be
used with the 433 MHz gray
button Key FOB.
1.2.3. 433 MHz receivers marked "RR" Version 2 can be used with either of the 433 MHz Key FOBS.
2. The receiver exits the program mode after ten seconds.
3. If the light does not come on above, the memory is full and must be cleared.
4. To clear the memory: press and hold the transmitter learn button for 5 seconds. While holding the button, the
indicator light should be off for the full 5 seconds then come on.
5. The system may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
DR020
TO
EYE PORT
on RP24
Program
Mode
Press to Learn
Transmitter
UP
Program
Button
Indicator
Light
Stop
RR
418 MHz
433 MHz
FCC ID OJM-CMD-KEYX-XXX
315MHz
418MHz
433MHz
FCC ID OJM-CMD-KEYX-XXX
315MHz 418MHz
433MHz
433 MHz
or
TO
EYE PORT
on RP24
Program
Mode
Press to Learn
Transmitter
UP
RR24
TO
EYE PORT
on RP24
Program
Mode
Press to Learn
Transmitter
UP
RR
RR24
RR
Version 1
RF Receiver
DR026a
TO
EYE PORT
on RP24
Program
Mode
Press to Learn
Transmitter
UP
RR
RR
Version 2
Rear Label
ONLY
ONLY
418 MHz
433 MHz
433 MHz
Manual Compliments of
Northwest RV Supply
Printed From
http://www.nwrvsupply.com
