INSTALLATION
PIN26GB
4
Remove all packaging before positioning the
machine.
Positioning
This dishwasher is designed to be fitted under a
kitchen counter or sink.
In either case, it is essential that the recess dimen-
sions are indicated in the picture are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hoses
and power supply cables pass through.
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher in-
corporates levelling feet adjustable over a wide range
(max 60 mm).
Adjust the height of the appliance by turning these
feet.
Good levelling is essential for correct closure and
sealing of the door.
If the door does not close correctly, loosen or tighten
the adjustable support feet, until the machine is
perfectly level.
Adjust the height of the plinth by following the
instructions shown in the figure.
Securing the machine under a counter
Open the door; vertically insert the two mounting
brackets (A) on the front part of the dishwasher and
turn them 90° (see fig.).
Secure the brackets to the counter by means of two
3.5 x 16 screws.
Caution
Once the machine has been installed, ensure that it
can be accessed easily for servicing.
Fitting a decor panel on the door
The door of this machine has frames for fitting a
plastic laminate decor panel in the colour required to
match the dishwasher with the rest of the kitchen
furniture. If you wish to do this you must provide the
panel yourself.
Width: 588 mm
Height: 586 mm
Max thickness: 4 mm
To fit the panel
Take the door frame off after removing the retaining
screws around the edge.
Position the panel, refit the frame and tighten the re-
taining screws around the edge.
Note:
The panel should be fitted before positioning the machine.
818 ÷ 878
577
596
600
820 ÷ 880
max
II49
0 ÷ 60mm
II06
IN10
1
2
A
90°
II18
A
AP01
