40
TROUBLESHOOTING AUDIOLINE FF895-2
IF THE CALLER DISPLAY DOES NOT WORK
If the Caller Display does not work, first make contact with your network provider to see
if:
# The service is activated in your area.
# Check that your subscription to the service is up to date.
# Ensure you have followed the instructions in this manual.
# Check that all cords and connections are correct.
NO CALLER DISPLAY INFORMATION ON INCOMING CALL
# Follow the directions above.
# If “OUT OF AREA” shows in the display it means that no information was sent, it
may have been an international call or from a PABX.
# If “PRIVATE” shows in the display it means that the call was from a “silent” number
or the caller had barred their number from being sent (Refer to the table on page 16).
NO DIAL TONE IS HEARD
P Have the handset batteries been charged for 14 hours?
P Is the Base connected to a mains power socket and mains power switched on?
P Is the telephone line cord plugged into a telephone Network wall socket?
THE DISPLAY ON THE HANDSET IS BLANK
P Is the handset battery charged?
THE BASE UNIT RINGS BEFORE THE HANDSET
P This is normal for all cordless telephones.
THE HANDSET WILL NOT CONNECT WITH AN INCOMING CALL WHEN
THE BASE UNIT RINGS
P Because this is a cordless telephone, the ringing signal has to be transmitted to
the handset which can take a few seconds. It is important that a call is not
picked-up on the handset until the handset rings.
THE HANDSET DOES NOT RING
P Is the ringer programmed Off? (see page 20).
MEMORY DIALLING DOES NOT WORK
P Store a new number and try again (see page 11).
