Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for
host reads and writes.
1.2. Package Contents
Serial ATA 2 Port CardBus Host Adapter
This User’s Manual
Driver CD
2. Software Installation
To use this CardBus adapter, the host computer must be equipped with one free
PCMCIA Card Type II or Type III slot. This section provides the information on how to
install the drivers of Serial ATA 2 Port CardBus Host Adapter for the Windows
operating systems:
2.1. Windows NT installation
1. Power off the system. Insert Serial ATA 2 Port CardBus into an available
CardBus slot. Connect serial ATA cable(s) between the Serial ATA 2 Port
CardBus and the serial ATA device(s). Power up the system.
2. After OS boots up, click 'Start'.
3. Under 'Settings', click 'Control Panel'.
4. Select 'SCSI Adapters' from the Control Panel.
5. Select the 'Drivers' tab and click 'Add'.
6. Click 'Have Disk'.
7. Insert the Driver CD into D: (D: represents CD-ROM) and press 'Enter'.
8. Choose 'Silicon Image SiI 3112 SATALink Controller' and click 'OK'.
9. After the driver installation has completed you can follow the instructions in
section 2.3 to verify controller was installed correctly.
2.2. Windows 2000/XP installation
1. Power off the system. Insert Serial ATA 2 Port CardBus into an available
CardBus slot. Connect serial ATA cable(s) between the Serial ATA 2 Port
CardBus and the serial ATA device(s). Power up the system.
2. During OS boot up, Windows will display the 'Found New Hardware Wizard'.
