19
Other devices on Network:
Sometimes you may have a large number of devices from various manufactures all on the same network.
ScreenCrop will detect all devices that are set to the Network Mask it is on. If this occurs and you select a
device that is not supported by ScreenCrop then, the status button will be grayed-out and
non-selectable. If you click “Change IP” then the following error message would appear.
Figure A-3 Device does not support ScreenCrop Utility (Error Message)
Method 2: Change the IP Address of the Controlling Computer
For Windows XP
Step 1. Click Start, right-click on My Network Places, then click Properties.
Step 2. When the next screen appears, right-click Local Area Connection icon, then click Properties.
Step 3. When next screen appears, click to check Internet Protocol (TCP/IP), then click Properties.
Step 4. When the next screen appears, click the radio button to select Use the following IP address:,
then enter the IP address: 210 . 100 . 100 . x (where x is any value from 1 – 253) and the
Subnet mask: 255 . 255 . 255 . 0.
Step 5. Click OK to exit.
For Windows 7
Step 1. Click Start and type in Network and Sharing Center.
Step 2. Click Change Adaptor Settings on the left.
Step 3. Right-click the Local Area Connection the Pacific is connected to and select Properties.
Step 4. When the next screen appears, click to check Internet Protocol Version 4 (TCP/IPv4), then
click Properties.
Step 5. When the next screen appears, click the radio button to select Use the following IP address:,
then enter the IP address: 210 . 100 . 100 . x (where x is any value from 1 – 253), and the
Subnet mask: 255 . 255 . 255 . 0.
Step 6. Click OK to exit.
