.•.---=--.
I.
i
t
I
F
"
II'~ =811
ID~I
Loading User Voices Only
Our main concern while creating these user voices was also to make complete sets of
registrations in order to give ideas and to show some of the possibilities in combining the
newly created user voices with the existing voices of your Electone.
We also realized that not everyone may want to use the registrations contained on tracks
(Song. No.) 1 through 6'and that some individuals might prefer to use the new voices in
conjunction with registrations already created.
f.
Therefore the same user voices found with registrations in tracks I through 6 will also be
found in tracks
7
through
12
but this time without registrations, thus allowing you to load the
user voices in your Electone without erasing the existing registration.
Directions:
\
A)
Load a registration of your own. from a disk or a ram cartridge.
B) Insert the disk
#1
from
TURl/JO
UPGJUDE and use "Song Select" to choose the desired
group of user voices.
, C)
Press "Normal Play" and wait until you hear the "chord", indicating than only user voices
I
\ have been loaded.
After the loading of user voices has been completed, press the button "Upper Orchestra" in
1\ (
the ensemble section (make sure all the others are in the off position); next press the button; \
I'
labeled
"I"
in the Upper Orchestra section and select voice
#91
in the Sub Data Control panel. \
Once again, the selection of voice
#91
must be done following these steps: \
A) Press the button "Upper Orchestra" in the ensemble section.
I
B) Press the button labeled "I"
in
the Upper Orchestra section.
C) Press the numbers "9" and "I" in the Sub Data Control panel.
1
D) Press "ENTER".
The same procedure should be followed if you wish to access a user voice from the Lower
Orchestra. Percussive, Lead or Bass section. Observe that the LCD screen will only show the
name of "USER I"; please refer to the charts of user voices in Part III to locate the desired
voice.
(\.
A-I
