6
2. SPECIFICATIONS
2.1 Model Number Description
The table below describes the numbering significance of the model numbers. For example, if the
model number is 48C6F45EXW, use the table to determine the meaning of the numbering and
lettering system.
2.2 Lift Specifications
There are many custom designs whose specifications may vary from those published for standard
models. Please consult the specific General Arrangement (GA) Drawing to obtain the specifications for
application-specific designs.
2.3 Load Capacity
Load capacity rating is stamped on a metal nameplate attached to lift. This figure is a net capacity
rating for a lift furnished with a standard platform. If optional items are installed on lift after leaving
manufacturer, deduct weight of these from load rating to obtain net capacity.
Do not exceed rated capacity of lift. Loading lift beyond its rated capacity is unsafe, will shorten
operational life of lift, and will void warranty.
2.4 Unbalanced Loading
The stabilization provided is basically for balanced loads. If special attachments extend beyond the
length and/or width dimensions of platform, end and/or side load capacity is reduced 2% for each one-
inch extension from center. If load is rolling onto platform (in any but fully-lowered position) end and/or
side load capacity is reduced by dividing the rated end/side load by 1.50 to establish an available
“axle” load.
2.5 Pump Pressure
This lift incorporates a unique, positive displacement pump. Therefore, standard factory models of
same manufacture cannot replace it.
Pump can operate efficiently at intermittent pressures up to 3200 PSI and continuous duty to 2500
PSI. The factory installed safety relief valve is factory-set to stay within parameters of pump and lift
requirements.
Cylinders
Family
Cylinders
Hundreds
B = 2
C = 3
E = 14.25”
F = 20”
DH = Double High
DW = Double Wide
